Product Description
NB EoTech XPS-3 type dot sight & G33-STS type triple booster set replica red
-EoTech XPS-3 A product that includes a replica of a third-generation magnifier (booster) to add magnification to horosite-type replica dot sites and EoTech-type holosites.
-By attaching a booster directly behind the dot site, you can add a magnification of about 3 times, and it can be used like a low magnification scope.
-[XPS-3 type dot site] Battery: One CR123A battery (Battery is not included) Red & Green switching light emitting QD mount, compatible rail width: 20mm
-[Booster (Magnifier)] Magnification: approx. 3 times The included mount also comes with a QD type spacer of approx. 7mm. (To adjust to the height of the reticle, fine adjustment may be required by increasing the bulk of the tape.)
-With a special hard case. (The contents are subject to change without notice.)
-When magnification is not required,
-Remove the booster mount from the sighting position by tilting it to the side by 90 degrees, It can also be used as a dot site alone.
XPS-3 type dot sight
Red & green switching light emission
With QD mount, compatible rail width: 20mm
Full length: Approximately 9.5cm
Height: about 6.3cm
Width: about 5.5cm
Weight: about 250g
Method of operation
Right button ----- Power ON / Brightness up
Left button ----- Luminance Down
Press and hold both left and right simultaneously to power off
NV button ----- Switches the color of the reticle (red / green)
Use battery: One CR123A battery (battery not included)
Booster (Magnifier)
Magnification: about 3 times
Attached mount is QD type
A 7mm spacer is also included.
(To adjust to the height of the reticle, fine adjustment may be required by increasing the bulk of the tape.)
Full length: Approximately 105mm
Weight: about 320g
With a dedicated hard case.
(The contents are subject to change without notice.)